Original Mac, Mac 128 or Mac Plus (the case looked the same)- front_plus.stl.front_supportTest.stl was printed with supports Everywhere. caseBack_supportTest.stl was printed with supports from the Build Plate Only. The toughest areas to support are the handle on the back and the details on the front with the disk opening and the slots for the SE and SE30 versions. There are 2 STLs used strictly to test supports. I arranged the back and front pieces so the support fins are oriented to make easy removal. I made a point to print it on the smooth plate. Sorry about the error.Īll parts were printed with a layer height of 0.20 in PLA. Important: I discovered an issue with misalignment of the screw hole in 2 of the fronts. The new ones will be up there soon as a remix of the original. If you have the old iUniker screen, those files are available on Thingiverse. There are also a couple of files you can use to test your supports without printing the entire part. I've also included the SketchUp file if you'd like to tweak the designs. I will plainly mark them for the Faux Disk and the SD card. Take a look at the instructions before deciding which build.īe aware of which case build you are following. For those of you with larger hands, V2 can be a little tricky to safely squeeze it all inside. The real difference in the build is the lack of space inside the case. The cost difference between the 2 versions is minor. It is inserted and removed similarly to a disk in real Mac Plus. Version 2 moves the SD card to the front of the Tiny Mac. Version 1 has a faux disk in the front of the Tiny Mac and the SD card accessible from the right side. You can now make a Mac Plus, SE, SE30 or Mac Classic. Here's a full set of both Metric and US wrenches.Īll the STLs should be oriented properly on the build plate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |